Installing the DOS ToolBox

Prev Next Home Home Table Of Contents Index

INSTALLING THE DOS TOOLBOX

The Computer Tyme DOS ToolBox may be used on any PC/XT/AT compatible system with a hard disk or network and at least 384k resident memory.

Turn on the system. When the prompt appears, insert the program disk in Drive A. At this point you can either create a new directory for the files or copy them into an existing directory. Whatever you choose, the files need to be in a directory which is "path accessible" (see "The Path Command.")

To make a directory, type MD, a space, and the name of the new directory. (Example: MD C:\TOOLBOX ) Then type CD space and the name of the new directory. To put the files in an existing directory, just type CD space and the name of the directory. At this point you are ready to copy the files from the floppy to the hard drive or network.

Next type copy a:*.* and press the Enter key. Then change disks and insert the second disk and repeat the process. If you are also installing MarxMenu, insert the MarxMenu disks and copy them as well. After the programs are copied, type INSTALL. This will unpack all the ToolBox Programs.

Prev Next Home Home Table Of Contents Index

Sponsors
Shopping
Forum
Forum
email
EMail
Index
Index
Home
Home